DCM-202EOL EOS

Cable Modem
היכן לקנות

תאור

Using the Ethernet port enables you to use a single connection to

the Internet or use a router to connect multiple computers to the

cable modem. You can also use multiple IP addresses from your

cable operator when using the Ethernet connection. When using the

Ethernet connection, do NOT install the modem drivers. They are

only for the USB connection.

You must contact your cable provider and register the MAC address of

the modem. The MAC address is located on the label on the modem.

Below are two common ways to connect your DCM-202 modem to

your network. The diagram on the left shows the connection with a

broadband router. The diagram on the right shows the connection

directly to a computer.

מאפיינים כללים

LED COLOR DESCRIPTION

Green

Orange-Blinking

Orange

Green

Green-Blinking

Green

Green-Blinking

Green

Green

Green-Blinking

Power

Cable

Status

ETH

USB

Cable modem is plugged in to an electrical outlet and

is receiving power

The modem is searching for the DOWNSTREAM

frequency

DOWNSTREAM frequency is locked. Searching

for UPSTREAM frequency

UPSTREAM frequency is locked

Modem is registering with the cable company’s

head-end

Modem is ready for data transfers

Valid Ethernet link status

Cable modem is transmitting/receiving data through

the Ethernet port

USB interface is connected

Data is being sent/received through the USB port


נתונים פיזיים

System Requirements

If any of the above items are missing, please contact your reseller.

CAT5 Ethernet Cable

• Windows® Vista™, XP, or 2000 operating system (USB only).

• Pentium processor equivalent (Pentium 166MHz or higher).

• The original Windows® Operating System CD-ROM or diskettes.

• TCP/IP protocol installed.

• An active USB or Ethernet port on your computer or a router.

תקנים

הורדות

איורים

DCM-202
מראה מקדימה

דף מידע

ראה גם